风雪武者多少分钟:Tutorial of Xbee Based Arduino Mega soliddigi UHF RFID Reader

In this tutorial, we are going to demo two parts:

1. Using the UHF demo GUI, and host PC GUI actively scans the tag over Xbee. This will demonstrate the RSSI and tag information. Arduino mega acts as a serial bridge between the UHF RFID reader and the Xbee.

2. Using the Arduino mega to issue scan tag command, and report the number of found tags on the LCD. Debug information is sent wirelessly to the serial terminal using Xbee.

Hardware:

• Arduino Mega
• Xbee
• Xbee 3.3V to 5V breakout board
• Xbee USB Adapter
• soliddigi TTL UART UHF RFID Reader
• soliddigi RFID Reader Antenna(902MHz-928MHz)
• 3V/2A DC Wall Adapter
• 2X16 LCD 1602

Pin 1 of Xbee (VCC) is connected to Arduino Mega's 5V.

Pin 2 of Xbee (DOUT) is connected to Arduino Mega's digital 1, TX.

Pin 3 of Xbee (DIN) is connected to Arduino Mega's digital 0, RX.

Pin 10 of Xbee (GND) is connected to Arduino Mega's ground.

Ground of RFID module is connected to Arduino mega's gound.

RX of RFID module is connected to Arduin mega's digital 18, TX1.

TX of RFID module is connected to Arduin mega's digital 19, RX1.

For the 16X 2 LCD:

pin 1 of LCD -> Ground

pin 2 of LCD -> +5V

pin 3 of LCD-> the center leg of a 10K potentimeter, where the other two legs are connected to 5V and ground.

pin 4 of LCD -> digital pin 12 of arduino mega

pin 5 of LCD -> Ground

pin 6 of LCD -> digital pin 11 of arduino mega

pin 11 of LCD -> digital pin 5 of arduino mega

pin 12 of LCD -> digital pin 4 of arduino mega

pin 13 of LCD -> digital pin 3 of arduino mega

pin 14 of LCD -> digital pin 2 of arduino mega

 The Xbee module on the PC side, which sits on the Xbee USB adapter, needs to be configureed to 115200.

Part 1: Scan tags using PC GUI over Xbee

The PC GUI can be downloaded from:

http://www.soliddepot.com/files_down/TTL UART USB UHF RFID Reader Module Demo GUI (Windows 7).rar.

The sample Arduino code can be downloaded from: http://www.soliddigi.com/download/showdownload.php?lang=en&id=228.

Launch the GUI, and add a serial reader.

Click the scan button:

Note: if it doesn't work, you can use serial terminal to monitor the PC sides's Xbee output, sometimes, if the power supply can't provide enough current, the RFID module will reset. This can be confirmed by checking to see if "hello" message pop up when you did a scan. If it does, that means the module restart due to low current from the wall adapter.

 Part 1: Scan tags using Arduino mega

The sample Arduino code can be downloaded from:http://www.soliddigi.com/download/showdownload.php?lang=en&id=229.

Now, in X-CTU, by pressing 'r', the LCD will display the number of tags found.

Note: the number of tags can vary. Multiple scans are needs to allow the collision avoidance.